at91: Support for the at91sam9g20 : Atmel 400Mhz ARM 926ej-s SOC.
AT91sam9g20 is an evolution of the at91sam9260 with a faster clock speed. The AT91SAM9G20-EK board is an updated revision of the AT91SAM9260-EK board. It is essentially the same, with a few minor differences. Here is the chip page on Atmel website: http://www.atmel.com/dyn/products/product_card.asp?part_id=4337 Signed-off-by: Justin Waters <justin.waters@timesys.com> Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com> Signed-off-by: Jean-Christophe PLAGNIOL-VILLARD <plagnioj@jcrosoft.com>
This commit is contained in:
committed by
Jean-Christophe PLAGNIOL-VILLARD
parent
118d168035
commit
df486b1fa3
@@ -447,14 +447,14 @@ static int macb_init(struct eth_device *netdev, bd_t *bd)
|
||||
/* choose RMII or MII mode. This depends on the board */
|
||||
#ifdef CONFIG_RMII
|
||||
#if defined(CONFIG_AT91CAP9) || defined(CONFIG_AT91SAM9260) || \
|
||||
defined(CONFIG_AT91SAM9263)
|
||||
defined(CONFIG_AT91SAM9263) || defined(CONFIG_AT91SAM9G20)
|
||||
macb_writel(macb, USRIO, MACB_BIT(RMII) | MACB_BIT(CLKEN));
|
||||
#else
|
||||
macb_writel(macb, USRIO, 0);
|
||||
#endif
|
||||
#else
|
||||
#if defined(CONFIG_AT91CAP9) || defined(CONFIG_AT91SAM9260) || \
|
||||
defined(CONFIG_AT91SAM9263)
|
||||
defined(CONFIG_AT91SAM9263) || defined(CONFIG_AT91SAM9G20)
|
||||
macb_writel(macb, USRIO, MACB_BIT(CLKEN));
|
||||
#else
|
||||
macb_writel(macb, USRIO, MACB_BIT(MII));
|
||||
|
||||
Reference in New Issue
Block a user